Amounts of metal from both ends of the blades along the. Sharpening or replacement. Changing the Deck Belt. A poorly balanced blade will cause. To change or replace. Test the blade's balance using a blade balancer. Cutting Deck Removal.
Remove the deck from beneath the tractor, (refer to. NOTE: On some decks it may be necessary to remove the. Spindle for cracks or damage, especially after you've. To remove the blades, proceed as follows. The V-belts found on your tractor are. A part number stamped in it) facing the ground when the. CAUTION: If the cutting edge of the blade has.
Periodically inspect the blade and/or. Specially designed to engage and disengage safely. And the cutting blade to act as a stabilizer. Previously been sharpened, or if any metal separation.
Machine, use factory approved belts. Replaced if any signs of wear are present. Remove the hex flange nut that secures the blade to the. Do not operate the machine. NOTE: When replacing the blade, be sure to install the. Flip the deck over to expose its underside.
Place a block of wood between the deck housing baffle. Blade spindle hex flange nut to between 70 ft-lbs. Is present, replace the blades with new ones. Cub cadet xt1 mower deck belt diagram. Mower is in the operating position. Struck a foreign object. Spindle covers to remove and/or install the new belt. Shut the engine off and remove. Loosen, but do not remove the hardware on the right and. A substitute (non-OEM) V-belt can be dangerous by.
Always grind each cutting blade edge equally to. Metal from the heavy side until it balances evenly. Using heavy gloves when grasping the blade. Until damaged components are replaced. Protect your hands by. Cutting Deck Removal earlier in this section) then gently. Cub cadet xt1 46 inch deck belt diagram. The deck belt on your tractor, proceed as follows: Remove the deck as instructed earlier in this section under. Maintain proper blade balance.