I. the driver's door is manual, the others are power locks). Whether it's to check your car's fluid levels, do the service, add windshield washer fluid, or swap your battery, it's important to keep your engine in good conditions. You will have to take off the front grille of your Volvo XC60 to access the lock on your stuck bonnet. Reset the lock mechanism in one of two ways: 1. remove it & manually work the mechanism to release & return to unlocked postion so that the link arm from the lock cylinder can move it; or (2) grab both link arms with needle nosed locking pliers and pull & push both until you hear a click. Are the symptoms I've described indicative of any part of the mechanism about to fail? Volvo XC60 Hood Latch Replacement | Cost & Service. Once I got that, the install was pretty easy. Dan R] There are two of those torsion springs on the lower hinge. Practice how much pulling and in which direction to go so as to minimize the wrinkles. There is a switch on the push/pull rod that is actuated by the knob on the driver's door. I also seem to have an issue with the bonnet release not working properly on my new to us 2007 XC90. Response: John Sargent] Look at two potential faults: Switch Defect.
I made a replacement pin using a Ford pin like the #A21098 retainer found @. Roughen the inner surface of the door pocket over the crack, clean with alcohol, apply the epoxy and reinforcing strips. Go to the front of the hood and press on the hood latch by sliding your hand under the hood. There is such a kit available from Volvo. Pull the hood release to pop open the hood. Response: Rick Klasic] Carefully pry off the 'lid' with a flat screwdriver. Hood Will Not Lock on Volvo S90 HELP. You need to push this catch towards the centre line of the car. If you blow from the top it may push the pipe out of the rubber. Volvo XC90 Hood won't Open. Switch to compress the hidden metal spring that's at the far end. As you fit the panel back in during reinstallation start at the top. I used Mobil 1 synthetic differential fluid on my door hinges and they have been noise free for about 6 or 7 months. I sussed the problem but couldn't get a long handled screw driver/small Bolster/Paint scraper to work. It just ain't gonna happen.
Included for free with this service. Thread this long wire up over the steering column and over to the free loom that passes thru the firewall just next to the Motronic brain. My trunk is locked shut: I only have the valet key and can't open it. It's also a good opportunity to clean and grease the moving parts. I had to adjust the rubber stops on the underside of the bonnet. Put it on the backing material AND the loose fabric. Just to say that I too had this problem tonight - prepping the car for a long journey from the Home Counties to Durham. Response: Bob/Rob Bareiss] The two lift struts are the only support and need to be replaced. Bonnet stuck on my Volvo XC60, what can I do. This 20 minute repair turned out well. Test to ensure it is all mounted securely. Stop peeling downward when you hit a defined edge (ie. On average, the cost for a Volvo XC60 Hood Latch Replacement is $301 with $111 for parts and $190 for labor. To do this, we are going to discover what can be the causes of a stuck bonnet on your Volvo XC60 and then what are the possibilities to remedy this trouble.
Note that the door harnesses can flex near the hinges and result in broken wires which cause intermittent failures of door components. Remove the lock with an allen key and detach the control arms and thoroughly lubricate it with some oil/ grease/ or equivalent. When the hood reaches the catch at the handle in the front edge of the vehicle, press down on the hood to close it completely. Volvo xc60 hood won't open 2015. Removal: - Unscrew the door lock vertical stem at the top of the door panel. Note that unecessary heating of the vinyl will only stretch it.
I had the luxury of having another Volvo sitting next to the one on which I was replacing the hinge. Door Panel Puckering in 93+ 900 Cars. If it bulges away from the window glass then you misses a spring clip or two. Locate the hood release under the dashboard on the driver's side.
The 'inner' part of the lock is located by a screw hidden behind the 'outer'and will therefore stay put during the operation. Dick Riess] If the spring is lifted slightly, it seems to cure the problem. This piece is loose and driving me crazy. Volvo xc60 hood won't open in a new window. If you are too cheap to get a replacement assembly like me, remove the spring from the rear door handle and use it on the front. Use a torch and a small mirror to find a hook in the opening (it is part of the locking mechanism) and pull it out. It gets your antenna up and out of the cars interior so it does a much better job.
Editor] Some aftermarket struts have cheap little spring clips that take some patience to install. Responses: Peter KL Milne] In another case, one of the sensor loops went open circuit, caused by the bonnet open/shut switch (at the front left-hand of the bonnet opening, very close to the bonnet spring retainer) having gone faulty. You have to go in from under the bumper, drop the belly pan, long arm up to the cable and pull/flex should release the two locks. We've used a product called vinylhyde that you can use to repair the tears. Without the seal, water goes straight for your distributor, which could cause problems. There are 2 PC boards atop one another. Reinstall it all and you're all set. Do NOT use WD-40 or the like to lube your locks. We come to you with all the necessary tools and parts. Door Operation and Troubleshooting: Fuel Door: Mirrors: Trunk/Boot: Tailgate: Trim: Repairing Panel and Lamp Posts. Strut Ball Joint Stud Breaks. Generate Transcript. The little knob is a catch that holds the door panel on. 09 inch size is perfect.
The relay is momentary in action and when you operate the switch manually, the locking coils are only held for less than a second. It might feel like the hood is latching, but once your car is moving, you'll realize that it was never all the way closed. For the $29 JC Whitney controller, I installed just above the drivers left foot and tapped into the wires from the switch in the drivers door (that lock and unlock the door) to the solenoid behind the fuses. I use Mobil 1 spray lube (tough to find). Response: Rob Bareiss] We've seen 960 door panels bunch up on both '95 and '96 cars. This is right from the Volvo green book. Pull the remaining trim up until it unlatches then pull it outward to remove it. Oh, you were looking for more info? Take a look at how this works when it is operating normally so you can repair it when it fails. Lube the lock cylinders and the inside mechanism using the spray tube on the aerosol can.
Open the Hood - How to pop the hood and prop it open. Audio volume control bar. You can remove the plastic piece from the handle by removing the pin that secures it to the handle. Herb Goltz] The covers often break at the bottom mounting clip, causing them to loosen or fall off. Good time to replace these if they don't work. There is a plastic piece on the door handle that hooks to the rod.
Do not even attempt to remove the door handle assembly. Stuck Due to Broken Glass. Tip from Ursula: Requires That You Merely Move the Trim Panel to Access Lock] This is how I got the stuck rear passenger side door open without destroying the panel. Easy, risk free: remove the rear seat, climb into the trunk, remove the trim, and repair the lock. My hood release cable broke, how do I open the hood. You may have to drill a small hole to hold a plastic snap or something.